Fall Protection Equipment

I often find that the reason most people don’t implement a good fall protection program, or are out of compliance is not because of a lack of knowledge, but an ignorance as to what equipment is available to assist in their fall protection needs. They may, or may not, perform a fall or hazard assessment, but once the hazard is identified they didn’t know how or what to use to help. The following are some examples of specialized equipment designed to help comply with the various fall hazards in construction.

20130421-152520.jpg

20130421-152530.jpg

20130421-152536.jpg

20130421-152555.jpg

20130421-152716.jpg

Be sure to read the manufacture instructions for installation procedures and application requirements prior to use. If the system fails, where does the liability fall if the system is not installed properly? Use the right tool for the application to ensure adequate fall protection is in place.

Safety Photo for May 2012

OK, perhaps I don’t fully understand the process. I have never seen a rock crusher/mill on top of the dirt/rock pile before. Typically they have this piece of equipment on the ground and the loader/excavator will bring the material to it. My concern is the fact that the excavator is digging out the material beneath the crusher…just my thought, but don’t you think  that might be a bad idea?

On another note, Caterpillar has a great web based resource on safety with construction equipment. If your looking for videos, toolbox talks, or other training material check it out.